.Type 1 bottom  cushions

 The bottom cushions on this type are not curved on the back corners.

         Refer to fig. 1

     As shown in this illustration (above) you need to measure the sofa deck from side to side and

front to back. You may want to measure the sofa distance (side to side) in the front and also

toward the back of the sofa because sometimes rattan or wicker sofas will taper down from

the front of the sofa to the back of the sofa.  click here to view our standard cushions

Type 2 bottom  cushions

 The bottom cushions on this type are curved on the back corners.

   click to view figure .2

        As illustrated in (figure 2) the bottom cushions on this type of  rattan and wicker furniture have a

curve on the back end corners. You can measure this curve by placing the end cushion on a piece of typing paper and then outlining the curve. Once you have the outlined the curve you can then fax it to us.

. click here to see a illustration of this process

 The back cushions  are the same on both type 1 and type 2 cushions.

     As shown in (figure 1) you need to measure the distance from the deck to the top of the sofa.

You can make the back cushions a bit higher than the top of the sofa or you can make the back

cushions a bit lower than the top of the sofa. This is your preference, but remember when you calculate the measurement for the back cushions be sure to subtract 5" because this is the thickness of the bottom cushion and the back cushion sits on top of  the bottom cushion. Also, most customers prefer us to round the outside corners of the back cushions.